The alternative sensor is the XS9C4A2A2N12 https://eshop.schneider-electric.com/product.aspx?org=21&lang=1&dist=276&prod_id=XS9C4A2A2N12
Read more
For difference between theses sensing mode please refer Detection for Automation solution Osi Sense. Page no 5/16. Please refer below link for more information https://www.arteanet.it/doc/Schneider/SCH_stranieri/Rilevamento_EN/00_summary.pdf
Read more
XE2SP2151 1N/O + 1N/C Snap action https://eshop.schneider-electric.com/product.aspx?org=21&lang=1&dist=276&prod_id=XE2SP2151
Read more
XCMN211AL1 basic limit switch is not a standard one (not shown into Osisense XC catalogue). It is an adapted switch requested by an Italian OEM. It is in fact an XCMN2110L1 switch (snap action contacts) assembled with the end plunger with silicone protective boot \'ZCE1A\' not sold separately and 1m cable length. The closest standard complete switch is the XCMN2110L1. Attached its datasheet. It cannot replace the XCMN211AL1 switch because the plunger head with protective boot is longer. Logistic situation...
Read more
The cables that you can use with the OSISense XGSZ33ETH are the following. XGSZ09L2 two meters XGSZ09L5 five meters XGSZ09L10 ten meters
Read more
Pin number | Function | Colour |
|---|---|---|
1 | 0 V | BK |
2 | Data (+) | BN |
3 | Clk (+) | GN |
4 | R | – |
5 | Direction | VT |
6 | Reset | BU |
7 | R | – |
8 | + V | RD |
9 | R | – |
10 | Data (-) | OG |
11 | Clk (-) | YE |
12 | R | – |
R: reserved, do not connect
