TSXCANKCDF90T
CANopen SUB-D9 female connector - bended at 90° - IP20
- Range of product
- CANopen
- Bus type
- CANopen
- Accessory / separate part category
- Connection accessories
- Accessory / separate part type
- Connector with line terminator
- IP degree of protection
- IP20
- Accessory / separate part destination
- CANopen bus
- Electrical connection
- 1 female connector SUB-D 9 elbowed
- Product weight
- 0.046 kg
- RoHS (date code: YYWW)
- Will not be compliant
- Warranty period
- 18 months
Frequently Asked Questions and Answers
- TeSys T Operating Modes and IO Logic
Issue: What are the different TeSys T Operating modes? How are they different? Product Line: TeSys T Motor Management Controller Environment: North American Products Cause: Installation and Application Resolution: There are six main types of operating modes. Overload, independent, reverser, two-step, two-speed, and custom operating mode. Each has different wiring as well as specific behaviors for the TeSys T inputs and outputs. See attached for more information. Operating M...
Read more - How to use TeSys T Custom Logic with SoMove
You will find in attach Presentation all basic step to create a custom Logic TeSys T motor management device T includes pre-defined modes and large possibilities to adjust parameters by configuring the product with SoMove. Before deciding to customize with specific Custom Logic, make sure you cannot meet customer needs with pre-defined mode and accurate configuration You can also easily change Input/Output behavior using only the Logic Input and Logic output dedicated area in pre-defined programs If Custo...
Read more - Can TeSys T be used for Single Phase application.
Yes, TeSys T can be used in Single Phase application. For a Single Phase application, you pass the First Phase cable through the first internal CT and the Second Phase cable/Neutral cable through the third internal CT.
Read more - Reset Button: combination starter with Tesys T
Issue: If a combination starter is ordered with a Tesys T overload relay will the door of the enclosure have a reset button? Product Line: Combination Starters Environment: NEMA Combination Starters Cause: Product Characteristics Resolution: Yes it will, unless the combination starter comes in a NEMA 12/3R which specifically excludes a reset button on the door. This can be seen by looking at the combination starter class and type in the Schneider Electric Digest.
Read more - What is the explanation of the Parameter FLC1 in TeSys T.
FLC1 is the parameter to enter the Motor nominal current in TeSys T. In this parameter, the Motor nominal current is entered as a percentage of the rated value of the TeSys T. Example: For TeSys T of range 8Amps (LTMR08) and a motor of 2 Amps nominal current, you have to set the FLC1 value to 25% because the Motor nominal current is 25% of the full load current of TeSys T Module (LTMR08). This means that the current in register 466 (value of current in percent) take the value of 100% when ...
Read more
